To repair a USB flash drive with the Alcor Micro AU6989SNGTC controller, you generally need the mass production tool.
The most reliable source for these specific controller tools and firmware is , which hosts a comprehensive archive of AlcorMP versions Recommended Tool Versions
For these specific controllers (GTC and SN series), look for the following on the AlcorMP download page AlcorMP (U2 MP) : Recent versions like v23.08.07.00.H v16.06.07.00
are often recommended for AU6989SN and AU6998SN series controllers. Alcor Change PID/VID Rework : This separate Rework tool alcor micro usb repair tool au6989sngtc au6998sn link
can be used if you only need to fix identification issues without a full reflash. Basic Repair Steps Identify Flash ID
: Use a tool like ChipGenius to confirm your controller is indeed AU6989SNGTC or AU6998SN. Download & Extract : Download the compatible version of and extract it to a folder. Run as Admin AlcorMP.exe . If the drive is not detected, you may need to edit the AlcorMP.ini file to include your specific VID/PID. Configuration
: Click "Setup" (password is usually blank) and select "Capacity Optimize" or "Speed Optimize" based on your needs. To repair a USB flash drive with the
: Press "Start" to begin the low-level format and firmware flash. This will erase all data on the drive. exact version based on your flash drive's memory chip (Flash ID)?
AlcorMP (Последняя версия ALCOR U2 MP v23.08.07.00.H)
In the world of data recovery and flash drive maintenance, few names carry as much weight—or cause as much confusion—as Alcor Micro. For technicians, hobbyists, and IT professionals, the phrase "Alcor Micro USB Repair Tool AU6989SNGTC AU6998SN Link" is more than a random string of characters; it is a gateway to resurrecting seemingly dead USB flash drives. The Ultimate Guide to the Alcor Micro USB
If you have a USB drive that is not detected, shows 0 bytes, or has been bricked by a failed firmware update, you have likely landed here looking for a solution. This article will dissect everything you need to know about the Alcor MPTool, focusing specifically on the AU6989SN-GTC and AU6998SN controllers, and provide the verified link and guidance you need to repair your device safely.
| Issue | Likely cause | Solution |
|-------|--------------|----------|
| Tool shows “No Device” | Wrong PID/VID, or USB 3.0 port | Use USB 2.0 port; edit AlcorMP.ini to add VID/PID |
| Format fails at 99% | Bad NAND or wrong tool version | Try older/newer AlcorMP version |
| Capacity shows 8 MB after repair | Firmware mismatch | Find exact match using Flash ID in tool database |
| Drive still read-only | Physical NAND write-protect or dead chip | Replace drive |
You’ll receive an email with download link shortly.
If not, reach us on solviamarketing@solviads.com