Ats20 Radio Manual Better |work|

are compact SI4732-based radio receivers covering FM, AM, LW, and SW bands, including Single Sideband (SSB)

. They are often sold without consistent branding and may require firmware updates or hardware adjustments for optimal performance. Essential Controls and Operation ATS20 & ATS20+ How to Reset

5.2 Memory (MR) Mode

Stores and recalls up to 20 frequencies with mode.
To store:
1. Tune to desired frequency, set correct mode (e.g., 7050 kHz LSB).
2. Press Memory button.
3. Use right encoder to select channel number (0–19).
4. Press right encoder to save.
To recall: Press VFO/MR to enter MR mode, rotate encoder to select channel.

Part 5: Firmware Updates – The Real "Better" Manual

The original factory firmware is buggy. To truly have a better manual, you need better software. The open-source community has created two superior firmwares: ats20 radio manual better

Si4735 Arduino Library UI (by PU2CLR): Turns your ATS20 into a professional tool. Adds spectrum scope, RDS, and Airband.
ATS20-Plus Enhanced: Fixes the squelch hysteresis and adds proper EEPROM saving.

How to flash (Simplified):

You need a USB-to-Serial adapter (like CP2102 or CH340).
Connect GND, RX, TX to the radio’s internal pads (or USB if supported).
You do not need the factory manual for this—search YouTube for "PU2CLR ATS20 flash."

Warning: The stock manual says not to flash. Ignore it. Flashing is the only way to fix the muting delay bug. are compact SI4732-based radio receivers covering FM, AM,

12. Safety & Maintenance

Do not expose to water or high humidity.
Do not press on the LCD glass.
Do not apply >5V to USB port.
Clean with dry microfiber cloth only.
Store battery at ~50% charge if unused for >3 months.

2. Mode Selection (The Side Buttons)

The buttons labeled SSB, CW, AM, and FM change the detection mode.

SSB (Single Side Band): This is where the ATS-20 shines.
- Use LSB (Lower Side Band) for listening to 160m and 80m amateur radio bands.
- Use USB (Upper Side Band) for 40m, 20m, and shortwave broadcasts.
- Tip: If voices sound like "Donald Duck," you are on the wrong sideband or your frequency is slightly off.

Part 2: Hardware Overview – Know Your Knobs

Let’s standardize the terminology. Most ATS20 units have the following physical controls: Stores and recalls up to 20 frequencies with mode

Encoder Knob (Center): Tune up/down. Push to enter the menu. Long push to mute.
Band +/- : Jump between amateur bands (80m, 40m, 20m, etc.).
Volume Pot: Usually on the side or top. (Note: Digital volume via menu is inferior to this analog pot).
3.5mm Jack: Headphones only. Does not output line-level audio well.
USB-C: Power only (5V). Data is generally not transferred over USB.

Pro Tip for a better manual: Never use the cheap telescopic antenna for LW (Longwave) or MW (Medium wave). Use a 3.5mm external loop antenna for frequencies under 5 MHz.

Part 7: The Ultimate ATS20 Cheat Sheet (Print this)

Since the manufacturer won't give you a "better manual," save this text file to your phone or print it out.

Welcome to the Magazine Stash