Becsys5 Installation And Technical Manual Official

Installation and Technical Manual is an advanced, expandable water chemistry controller designed for commercial aquatic facilities such as pools, water parks, and fountains. This guide provides a technical overview of installation, wiring, and system specifications. 1. Technical Specifications

is available in two primary voltage configurations and offers extensive input/output capabilities Electrical Ratings 115VAC Model : 60Hz, Single Phase, 12.25 Amps Full Load. 230VAC Model : 50Hz, Single Phase, 12.125 Amps Full Load. Standard Relays : Four (4) solid-state relay outputs (3A each).

: Up to 15 additional relays (total 19-24) using SRX or MRX modules. Input Capabilities Standard Probes

: Proprietary pH, ORP, and temperature sensors (36” or 10’ cable lengths). Advanced Monitoring becsys5 installation and technical manual

: TruePPM™ sensors (Free, Total, and Combined Chlorine), Total Alkalinity, Conductivity (TDS), and Turbidity. Analog Outputs

: Up to eight separately isolated 4-20mA outputs for VFD control or data recording. 2. Installation Guidelines

Proper mounting and plumbing are critical for accurate sensor readings and system safety. Mounting & Location Environmental Conditions Installation and Technical Manual is an advanced, expandable

: The unit must be mounted in a protected area. For convenience, it is often pre-assembled on a back panel with the flow cell. Safety First

: Components must be mounted and pressure tested before any electrical wiring begins. Emergency Off : Ensure the front-panel Emergency Off button is easily accessible. Plumbing the Sample Stream BECSys5 Installation and Technical Manual - Googleapis.com

The BECSys5 Installation and Technical Manual (Document 8620112) provides comprehensive instructions for mounting, wiring, and configuring the water chemistry controller, including setup for sensors and flowmeters. It covers hardware installation, software configuration, and maintenance, with details on integrating optional equipment like conductivity sensors. Access the full manual from the official documentation, such as the PDF hosted at BECS Technology Support Page storage.googleapis.com BECSys5 Installation and Technical Manual - Googleapis.com Use BECSys Scan tool → Scan 10

6.1 BACnet Discovery

• Use BECSys Scan tool → Scan 10.10.10.0/24.
• Verify device instance 5001 appears with correct name.

10.2 Firmware Update Procedure

1. Download becsys5-fw-5.2.x.bin from BEC.
2. Web UI → System → Firmware → Upload.
3. System will verify checksum (SHA256).
4. Confirm update (system will reboot).
5. Re-upload license if major version changes.

3.3 License Activation

BECSys5 uses a hardware-locked license via a USB dongle (Sentinel HASP).

• Insert the green USB dongle into a rear motherboard port.
• Open BECSys5 License Manager → Activate → Online Activation.
• Enter the 20-character license key from your certificate.
• After activation, verify in “License Status” that all modules (Batch, Recipe, Reporting) show “Valid.”

If offline, use the offline activation file (request.c2v) sent to support@becsys.com.