Digi Sm 5000 Scale User Manual Page

Digi SM-5000 Scale — User Manual (Concise Write-up)

3.1 Weighing Mode

1. Ensure the platform is empty and display shows 0.000.
2. Place object on the center of the platform.
3. Read the stable weight (a stability indicator, often an asterisk or circle, will appear).
4. To weigh another item, press [ZERO] only if the platform is empty. If using a container, use [TARE].

Connectivity (optional)

• RS-232 / USB: use included cable or accessory to connect to PC, printer, or POS. Configure baud rate/format in settings as needed. Use Print function to send weight data.
• Wireless/Bluetooth (if available): pair via device settings; consult advanced config section.

6. Calibration & Setup (Service Level)

• Enter calibration – Usually press FUNC → 8 → 0 → 0 → 0 → ENTER (password may be required).
• Use certified test weights equal to scale capacity (e.g., 5 kg, 15 kg, 30 kg).
• Follow display prompts – Zero → place test weight → confirm value.

Caution: Calibration affects legal-for-trade accuracy. Consult a certified technician.

Troubleshooting (common)

• Display shows overload: Remove load immediately; reduce weight below capacity.
• Unstable readings: Ensure stable surface, remove drafts, re-zero, check for nearby vibration/electromagnetic interference.
• Display blank: Check power adapter and connections; verify battery charge.
• Inaccurate readings: Re-zero and calibrate with certified weights.
• Error codes: Refer to error code table in full manual (E01–E99 descriptions).