Fujitsu Irmc S4 License Key Install -

Here’s a technical write-up on installing a license key for Fujitsu iRMC S4 (Integrated Remote Management Controller).

Steps:

1. SSH into iRMC
   ssh admin@<iRMC_IP_address>

2. View current license status
   rmccli license show fujitsu irmc s4 license key install

3. Install new license from file

   • First copy license file to iRMC (if not already present):
     scp license.xml admin@<iRMC_IP>:/tmp/
   • Then install:
     rmccli license install --file /tmp/license.xml

4. Install using raw license key string
   rmccli license install --key "XXXXX-XXXXX-XXXXX-XXXXX-XXXXX" Here’s a technical write-up on installing a license

5. Verify installation
   rmccli license show → should list newly installed license and features

6. Reboot iRMC if needed
   rmccli system restart Steps:

5.2 SSH / CLI Installation

1. SSH to iRMC: ssh ADMIN@<iRMC_IP>.
2. Authenticate as administrator.
3. Locate license command utilities; common command patterns (example — actual commands depend on firmware):
   • show license
   • install license <path/to/licensefile>
   • set license activation
4. Upload license file using SCP/SFTP to a temporary directory on the iRMC (if supported) or paste activation code.
5. Run install command and confirm.
6. Verify with show license or equivalent command.

Example (illustrative):

scp license_file.lic admin@<iRMC_IP>:/tmp
ssh admin@<iRMC_IP>
licensemgr install /tmp/license_file.lic
licensemgr list

(Commands vary; consult iRMC command reference for exact CLI syntax.)

7. Post-Installation Verification

After successful installation, confirm that advanced features are enabled:

• Remote Console (KVM) – Available under Remote Management → Remote Console
• Virtual Media – Check Media → Virtual Media tab
• Power Monitoring – System Information → Power Consumption
• CLI check – rmccli license show should list license type (e.g., "iRMC S4 Advanced Pack")

1. Prerequisites

• iRMC S4 enabled server (e.g., PRIMERGY RX/TX series).
• Valid license file (.lic) or license key string from Fujitsu.
• Network access to iRMC (via web browser or SSH).
• Administrator credentials for iRMC.

4. Post-Installation Check

After installation, test advanced features (if licensed):

• Remote Console (KVM) – should launch without restriction.
• Virtual Media – mount ISO over network.
• Power management – remote on/off/reset.
• System Event Log access via iRMC.