Huawei Bg2-u01 Test Point [top] Page

Huawei BG2-U01 Test Point: The Ultimate Guide to Unbricking and Factory Recovery

Frequently Asked Questions (FAQ)

Q: Will this method unlock the bootloader? A: No. The test point forces download mode, not fastboot. To unlock the bootloader on BG2-U01, you still need an unlock code from Huawei (service discontinued) or use a bootloader unlock tool like HCU Client after unbricking via test point.

Q: I have a BG2-U01 with a "Locked State: Locked" warning. Can test point fix this? A: Yes. If you flashed an unsigned image, the device enters "Red State" or "Orange State." Using the test point to flash the official stock firmware will restore the "Green State" (Locked). huawei bg2-u01 test point

Q: Do I need to remove the motherboard to find the test point? A: Usually no. On the BG2-U01, the test points are accessible just by removing the plastic mid-frame. You do not need to desolder the RF shields. Huawei BG2-U01 Test Point: The Ultimate Guide to

⚠️ WARNING

• Performing this procedure will void any remaining warranty.
• Incorrectly shorting the wrong pins can permanently damage the motherboard.
• This process requires opening the device and disconnecting the battery.

Step 4: Flashing Firmware via Test Point

Once your PC recognizes the device in BROM mode (Check Device Manager -> Ports -> MediaTek USB Port), proceed to flash. Performing this procedure will void any remaining warranty

1. In SP Flash Tool, ensure only "Download Only" mode is selected (not "Format All").
2. Click "Download".
3. The writing process will take 3–5 minutes.
4. When a green "Download OK" circle appears, close the tool.
5. Disconnect the USB cable. Remove the battery for 10 seconds, reinsert it, and press the power button.

Your Huawei BG2-U01 should now boot to the setup screen.