V2000-c Rfid Access Control User Manual |link| Site

The V2000-C RFID Access Control is a standalone, single-door system supporting card-only, PIN-only, and card+PIN authentication modes with up to 2,000 user capacity. Key features include a Wiegand 26 interface, Tamper alarms, adjustable door delay, and compatibility with 125KHz EM cards. For more detailed technical specifications, visit goldbridgesz.com www.goldbridgesz.com

The V2000-C RFID Access Control is a standalone 125KHz EM card system supporting up to 1,000 users, offering adjustable door open times, and featuring a rugged plastic, non-waterproof design. While praised for its fast response time and versatility, users often report complex programming procedures. For official setup instructions, you can download the V2000-C User Manual directly from Obohands. programming NTIL V2000-c+ RFID Access Keypad - JustAnswer V2000-c Rfid Access Control User Manual

The V2000-C RFID Access Control system is a standalone device supporting up to 2,000 users with card-only, PIN-only, or combined verification modes for single-door security. It features a stainless steel design, 12V DC power requirements, and supports Wiegand 26-bit interfacing for integration. Detailed instructions for installation and user enrollment can be found in the savebase.com manual www.goldbridgesz.com The V2000-C RFID Access Control is a standalone,

Since "V2000-C" is a popular model produced by various access control manufacturers (most notably by ZKTECO or as a generic OEM model sold under brands like Generic/Vision), the exact manual layout can vary slightly. However, the functionality is almost identical across these devices. Integrations and advanced uses

Below is a Feature Look based on the standard V2000-C configuration. This summarizes the key capabilities you would find in the user manual, categorized by how they are used.

Integrations and advanced uses

  • Network or serial integration: connect to a central access control system for enterprise-level management and consolidated logs if the model supports it.
  • Alarm system integration: configure door-forced or door-held alarms to trigger your overall alarm system.
  • Time-and-attendance: use logs to help with staff attendance tracking, ensuring compliance with privacy rules and labor regulations.

4.2 Wiring Diagram (Simplified)

| Controller Terminal | Connects To | | :--- | :--- | | 12V+ / GND | Power adapter (12V DC) | | NO / COM | Electric lock (Normally Open) | | NC / COM | Electric lock (Normally Closed) | | PUSH | Exit button (momentary switch) | | D-IN | Door contact/magnetic sensor |

⚠️ Do not apply AC mains directly to the relay terminals.

Monthly Checklist:

  1. Keypad clean: Wipe with damp (not wet) microfiber. Do not use solvents.
  2. Wire inspection: Ensure no rodent damage or corrosion at terminals.
  3. Lock voltage test: Under load, the relay should have <0.5V drop.
  4. User audit: Delete departed employees using 14 [ID]#.